bonding: enable netpoll without checking link status

Only slaves that are up should transmit netpoll frames, so there is no
need to check to see if a slave is up before enabling netpoll on it.
This resolves a reported failure on active-backup bonds where a slave
interface is down when netpoll was enabled.

Signed-off-by: Andy Gospodarek <[email protected]>
Tested-by: WANG Cong <[email protected]>
Signed-off-by: David S. Miller <[email protected]>

diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
index 27c413aa15da06c24b711c8d493682c8d056c80e..1a6e9eb7af431b8d7d833da233f7a44106775874 100644 (file)
--- a/drivers/net/bonding/bond_main.c
+++ b/drivers/net/bonding/bond_main.c
@@ -1347,8 +1347,6 @@ static int bond_netpoll_setup(struct net_device *dev, struct netpoll_info *ni)
 
        read_lock(&bond->lock);
        bond_for_each_slave(bond, slave, i) {
-               if (!IS_UP(slave->dev))
-                       continue;
                err = slave_enable_netpoll(slave);
                if (err) {
                        __bond_netpoll_cleanup(bond);