After acquiring the SAN MAC address from the EEPROM, we need to program it
into one of the RARs. Also, DCB will use this MAC address to run DCBX
commands, so it doesn't have to play musical MAC addresses when things like
bonding enter the picture. So we need to return the MAC address through
the netlink interface to userspace.
This also moves the init_rx_addrs() call out of start_hw() and into
reset_hw(). We shouldn't try to read any of the RAR information before
initializing our internal accounting of the RAR table, which was what
was happening.
Signed-off-by: Peter P Waskiewicz Jr <[email protected]>
Signed-off-by: Jeff Kirsher <[email protected]>
Signed-off-by: David S. Miller <[email protected]>
IXGBE_WRITE_REG(hw, IXGBE_AUTOC, hw->mac.orig_autoc);
}
+ /*
+ * Store MAC address from RAR0, clear receive address registers, and
+ * clear the multicast table
+ */
+ hw->mac.ops.init_rx_addrs(hw);
+
/* Store the permanent mac address */
hw->mac.ops.get_mac_addr(hw, hw->mac.perm_addr);
}
}
+ /*
+ * Store MAC address from RAR0, clear receive address registers, and
+ * clear the multicast table. Also reset num_rar_entries to 128,
+ * since we modify this value when programming the SAN MAC address.
+ */
+ hw->mac.num_rar_entries = 128;
+ hw->mac.ops.init_rx_addrs(hw);
+
/* Store the permanent mac address */
hw->mac.ops.get_mac_addr(hw, hw->mac.perm_addr);
/* Store the permanent SAN mac address */
hw->mac.ops.get_san_mac_addr(hw, hw->mac.san_addr);
+ /* Add the SAN MAC address to the RAR only if it's a valid address */
+ if (ixgbe_validate_mac_addr(hw->mac.san_addr) == 0) {
+ hw->mac.ops.set_rar(hw, hw->mac.num_rar_entries - 1,
+ hw->mac.san_addr, 0, IXGBE_RAH_AV);
+
+ /* Reserve the last RAR for the SAN MAC address */
+ hw->mac.num_rar_entries--;
+ }
+
reset_hw_out:
return status;
}
/* Identify the PHY */
hw->phy.ops.identify(hw);
- /*
- * Store MAC address from RAR0, clear receive address registers, and
- * clear the multicast table
- */
- hw->mac.ops.init_rx_addrs(hw);
-
/* Clear the VLAN filter table */
hw->mac.ops.clear_vfta(hw);
u8 *perm_addr)
{
struct ixgbe_adapter *adapter = netdev_priv(netdev);
- int i;
+ int i, j;
for (i = 0; i < netdev->addr_len; i++)
perm_addr[i] = adapter->hw.mac.perm_addr[i];
+
+ if (adapter->hw.mac.type == ixgbe_mac_82599EB) {
+ for (j = 0; j < netdev->addr_len; j++, i++)
+ perm_addr[i] = adapter->hw.mac.san_addr[j];
+ }
}
static void ixgbe_dcbnl_set_pg_tc_cfg_tx(struct net_device *netdev, int tc,