Change register_for_each_vma() to take mm->mmap_sem for writing.
This is a bit unfortunate but hopefully not too bad, this is the
slow path anyway.
This is needed to ensure that find_active_uprobe() can not race
with uprobe_register() which adds the new bp at the same
bp_vaddr, after find_uprobe() fails and before
is_swbp_at_addr_fast() checks the memory.
IOW, this is needed to ensure that if find_active_uprobe()
returns NULL but is_swbp == true, we can safely assume that it
was the "normal" int3 and we should send SIGTRAP.
There is another reason for this change. We are going to replace
uprobes_state->count with MMF_ flags set by register/unregister
and cleared by find_active_uprobe(), and set/clear shouldn't
race with each other.
Signed-off-by: Oleg Nesterov <[email protected]>
Acked-by: Srikar Dronamraju <[email protected]>
Cc: Ananth N Mavinakayanahalli <[email protected]>
Cc: Anton Arapov <[email protected]>
Cc: Linus Torvalds <[email protected]>
Cc: Masami Hiramatsu <[email protected]>
Cc: Peter Zijlstra <[email protected]>
Link: http://lkml.kernel.org/r/[email protected]
Signed-off-by: Ingo Molnar <[email protected]>
}
mm = vi->mm;
- down_read(&mm->mmap_sem);
+ down_write(&mm->mmap_sem);
vma = find_vma(mm, (unsigned long)vi->vaddr);
if (!vma || !valid_vma(vma, is_register)) {
list_del(&vi->probe_list);
kfree(vi);
- up_read(&mm->mmap_sem);
+ up_write(&mm->mmap_sem);
mmput(mm);
continue;
}
vaddr != vi->vaddr) {
list_del(&vi->probe_list);
kfree(vi);
- up_read(&mm->mmap_sem);
+ up_write(&mm->mmap_sem);
mmput(mm);
continue;
}
else
remove_breakpoint(uprobe, mm, vi->vaddr);
- up_read(&mm->mmap_sem);
+ up_write(&mm->mmap_sem);
mmput(mm);
if (is_register) {
if (ret && ret == -EEXIST)