ARM: dts: sun9i: Add GPIO LEDs for A80 Optimus board

The A80 Optimus board has 3 usable LEDs that are controlled via GPIO.

This patch adds support for 2 of them which are driver by GPIOs in the
main pin controller. The remaining one uses GPIO from the R_PIO
controller, which we don't support yet.

Signed-off-by: Chen-Yu Tsai <[email protected]>
Signed-off-by: Maxime Ripard <[email protected]>

diff --git a/arch/arm/boot/dts/sun9i-a80-optimus.dts b/arch/arm/boot/dts/sun9i-a80-optimus.dts
index 955436aa91d4072a9558aabfbe129a9fd97acd87..87b1355e3cd7b866c675ac549e683c5b51693882 100644 (file)
--- a/arch/arm/boot/dts/sun9i-a80-optimus.dts
+++ b/arch/arm/boot/dts/sun9i-a80-optimus.dts
@@ -64,6 +64,13 @@
                                /* Enable internal pull-up */
                                allwinner,pull = <1>;
                        };
+
+                       led_pins_optimus: led-pins@0 {
+                               allwinner,pins = "PH0", "PH1";
+                               allwinner,function = "gpio_out";
+                               allwinner,drive = <0>;
+                               allwinner,pull = <0>;
+                       };
                };
 
                uart0: serial@07000000 {
@@ -78,4 +85,24 @@
                        status = "okay";
                };
        };
+
+       leds {
+               compatible = "gpio-leds";
+               pinctrl-names = "default";
+               pinctrl-0 = <&led_pins_optimus>;
+
+               /* The LED names match those found on the board */
+
+               led2 {
+                       label = "optimus:led2:usr";
+                       gpios = <&pio 7 1 0>;
+               };
+
+               /* led3 is on PM15, in R_PIO */
+
+               led4 {
+                       label = "optimus:led4:usr";
+                       gpios = <&pio 7 0 0>;
+               };
+       };
 };