USB: EHCI: remove wrong debug message for port speed

It displays wrong debug message if we plug in a full/low
speed device at port for builtin TT controller. We can get
device/port speed information at following code of hub_port_init,
so it is better to replace it with debug message of "reset complete".

Signed-off-by: Peter Chen <[email protected]>
Acked-by: Alan Stern <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>

diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c
index 256fbd42e48c19b02c808fccda6025b93a3392c5..8f57c6e86e87f143c71fda6f9560d3c13f9f43ea 100644 (file)
--- a/drivers/usb/host/ehci-hub.c
+++ b/drivers/usb/host/ehci-hub.c
@@ -536,7 +536,8 @@ static int check_reset_complete (
                if (ehci->has_amcc_usb23)
                        set_ohci_hcfs(ehci, 1);
        } else {
-               ehci_dbg (ehci, "port %d high speed\n", index + 1);
+               ehci_dbg(ehci, "port %d reset complete, port enabled\n",
+                       index + 1);
                /* ensure 440EPx ohci controller state is suspended */
                if (ehci->has_amcc_usb23)
                        set_ohci_hcfs(ehci, 0);