Specifications:
* SoC: Qualcomm Atheros AR9344 (560 MHz)
* RAM: 64MB
* Storage: 8 MB
* Wireless: 2.4GHz N based built into SoC 2x2
* Ethernet: 2x 100/10 Mbps, integrated into SoC, 24V POE IN
Installation:
Flash factory image through stock firmware WEB UI
or through TFTP:
To get to TFTP recovery just hold reset button while powering on for
around 4-5 seconds and release.
Rename factory image to recovery.bin
Stock TFTP server IP:192.168.0.100
Stock device TFTP address:192.168.0.254
Signed-off-by: Adrian Schmutzler <[email protected]>
ucidef_set_led_switch "wan_data" "WAN Data" "tp-link:white:internet" "switch0" "0x02" "" "tx rx"
ucidef_set_led_switch "wan_link" "WAN Link" "tp-link:white:wan" "switch0" "0x02" "" "link"
;;
+tplink,cpe210-v1)
+ ucidef_set_led_netdev "lan0" "LAN0" "tp-link:green:lan0" "eth1"
+ ucidef_set_led_switch "lan1" "LAN1" "tp-link:green:lan1" "switch0" "0x10"
+ ucidef_set_rssimon "wlan0" "200000" "1"
+ ucidef_set_led_rssi "rssilow" "RSSILOW" "tp-link:green:link1" "wlan0" "1" "100"
+ ucidef_set_led_rssi "rssimediumlow" "RSSIMEDIUMLOW" "tp-link:green:link2" "wlan0" "30" "100"
+ ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" "tp-link:green:link3" "wlan0" "60" "100"
+ ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "tp-link:green:link4" "wlan0" "80" "100"
+ ;;
tplink,cpe210-v2|\
tplink,cpe210-v3)
ucidef_set_led_netdev "lan" "LAN" "tp-link:green:lan" "eth0"
;;
comfast,cf-e110n-v2|\
comfast,cf-e120a-v3|\
+ tplink,cpe210-v1|\
ubnt,nanostation-m|\
ubnt,routerstation)
ucidef_set_interfaces_lan_wan "eth1" "eth0"
ucidef_add_gpio_switch "led_control" "LED control" "21" "0"
ucidef_add_gpio_switch "led_reset" "LED reset" "19" "1"
;;
+tplink,cpe210-v1)
+ ucidef_add_gpio_switch "poe_passthrough" "PoE Passthrough" "20"
+ ;;
ubnt,nanostation-ac)
ucidef_add_gpio_switch "poe_passthrough" "PoE Passthrough" "3"
;;
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar9344_tplink_cpexxx-v1.dtsi"
+
+/ {
+ compatible = "tplink,cpe210-v1", "qca,ar9344";
+ model = "TP-Link CPE210 v1";
+};
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar9344_tplink_cpexxx.dtsi"
+
+/ {
+ aliases {
+ led-boot = &system;
+ led-failsafe = &system;
+ led-running = &system;
+ led-upgrade = &system;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ lan0 {
+ label = "tp-link:green:lan0";
+ gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+ };
+
+ lan1 {
+ label = "tp-link:green:lan1";
+ gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+ };
+
+ link1 {
+ label = "tp-link:green:link1";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ };
+
+ link2 {
+ label = "tp-link:green:link2";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ };
+
+ link3 {
+ label = "tp-link:green:link3";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ };
+
+ system: link4 {
+ label = "tp-link:green:link4";
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+ };
+};
+
+&gpio {
+ gpio_ext_lna0 {
+ gpio-hog;
+ gpios = <18 0>;
+ output-high;
+ line-name = "tp-link:ext:lna0";
+ };
+
+ gpio_ext_lna1 {
+ gpio-hog;
+ gpios = <19 0>;
+ output-high;
+ line-name = "tp-link:ext:lna1";
+ };
+};
+
+ð1 {
+ status = "okay";
+
+ mtd-mac-address = <&info 0x8>;
+
+ gmac-config {
+ device = <&gmac>;
+ switch-phy-swap = <0>;
+ switch-only-mode = <1>;
+ };
+};
+
+ð0 {
+ status = "okay";
+
+ phy-handle = <&swphy4>;
+
+ mtd-mac-address = <&info 0x8>;
+};
endef
TARGET_DEVICES += tplink_archer-c7-v5
+define Device/tplink_cpe210-v1
+ $(Device/tplink-loader-okli)
+ ATH_SOC := ar9344
+ IMAGE_SIZE := 7680k
+ DEVICE_MODEL := CPE210
+ DEVICE_VARIANT := v1
+ DEVICE_PACKAGES := rssileds
+ TPLINK_BOARD_ID := CPE210
+ SUPPORTED_DEVICES += cpe210
+endef
+TARGET_DEVICES += tplink_cpe210-v1
+
define Device/tplink_cpe210-v2
$(Device/tplink-safeloader)
ATH_SOC := qca9533