nilfs2: add missing blkdev_issue_flush() to nilfs_sync_fs()

nilfs2: add missing blkdev_issue_flush() to nilfs_sync_fs()

Under normal circumstances nilfs_sync_fs() writes out the super block,
which causes a flush of the underlying block device.  But this depends
on the THE_NILFS_SB_DIRTY flag, which is only set if the pointer to the
last segment crosses a segment boundary.  So if only a small amount of
data is written before the call to nilfs_sync_fs(), no flush of the
block device occurs.

In the above case an additional call to blkdev_issue_flush() is needed.
To prevent unnecessary overhead, the new flag nilfs->ns_flushed_device
is introduced, which is cleared whenever new logs are written and set
whenever the block device is flushed.  For convenience the function
nilfs_flush_device() is added, which contains the above logic.

Signed-off-by: Andreas Rohner <[email protected]>
Signed-off-by: Ryusuke Konishi <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
Signed-off-by: Linus Torvalds <[email protected]>